Reviewed by Justin
May 25, 2016

This is an extremely hard to find accessory for any Subaru. This one fit my 2008 legacy outback xt perfectly. Extremely low profile, they look as if the vehicle came with them. Doors can open freely and it helps block out the rain as well as reduce noise from the frameless windows when driving highway.

Reviewed by J. W. Osborne
April 21, 2013

I looked everywhere to find a vent visor for our '07 Outback. I found these and they look great and work very well. Great product for rain and heat.

Reviewed by L.J.H.
June 9, 2016

Came wrapped well, even though the shipping box had been torn. No damage & after letting them warm in the sun an hour, they were easy to mold and apply onto Baja.

Reviewed by suburbanloki
May 12, 2015

I have a 2008 outback. These aren't supposed to be mounted on the rubber as the car has a frameless window. There is no rain guard available that mounts to the rubber. However, these mount just above the rubber with no problem. I had the old two piece system and this one is much better. The last rain guard I had lasted 7 years before the plastic cracked in -10° weather. MAKE SURE YOU PREP RIGHT. I have had rain guards on 4 vehicles. Clean the surface. Alcohol pads, a little acetone, whatever you can use to make sure there is no wax on the paint. DO NOT APPLY ON A HUMID DAY. Wait until it is fairly dry out to apply and make sure it's not going to rain for at least 24 hours until the 3M tape sets. DO NOT APPLY IN THE DIRECT SUN. This will warm the tape and screw up the adhesion process. If you install these correctly you will have to peel the tape off your car 7 years later like I had to. Use two people. Find a good fit where it just clears the window and install.

LIFT THE CORNER OF THE TAPE and only work 4 inches at a time. Just pull the red tape backing straight up and slowly line up the visor on your car. It'll come out just fine. A lot of other reviews on here are by people who didn't take the time to do it correctly. Follow my instructions and you'll probably sell the car before you have a problem with them.

Reviewed by MITCH ABERASTURI
May 24, 2014

2005 Subaru Baja, Read reviews prior buying which made me skeptical if the window visor will work. They were fine. There is 1 unit per side and as others said they have to stick to car body ( painted surface ) but with caution and take your time you can pre-fit prior pulling tape strip. I marked with masking tape prefered layout. Which is right above black trim piece above windows. I practice with windows fully up that I could open and close the door and clear the visor. I have 1/4" clearance and do not need to open windows to open doors. Yet the product does protect as required. I have had them installed 3 weeks and parked at work with windows open over 1/2 inch all 4 windows had a very hard rain storm with wind and no water got inside the vehicle. The product works but take patience and planning and pre-measuring to get installed to work and look good and do what the product is designed to do. 3M tape could be better used super glue in a few places that was not sticking well.. Hope this helps. My first review but felt that the product works but it not just peel and stick and think it will work. It has to placed on the painted surface of the vehicle. But does what it is designed to do...

Reviewed by David Kovacs
Saturday, June 17, 2017 11:02 PM

I purchased this for my 2004 Subaru Legacy GT Wagon and it fit perfectly,and easily much better than others I have purchased from other companies supposedly made for this car. My only complaint would be that the shipping cost is quite high.

NOTE:
The reviewer lives outside of our free shipping zone and opted to pay for shipping of this oversized item which is surcharged as a result.